PiKonek
  • Get Started
    • Introduction
    • Prerequisites
  • Installing
    • Install in PC
    • Install in Virtual Machine
    • Install in Orange Pi One/PC
    • Install in Raspberry Pi 3B+/4B
  • Guides
    • How to access the administrator dashboard
    • How to update the software
    • How to change admin password
    • How to add network interfaces
      • Adding lan interface
      • Adding vlan interface
      • Adding wlan interface
      • Adding bridge interface
    • How to enable dhcp on network interface
    • How to enable captive portal
    • Manage connected users
    • How to enable remote management(Ngrok)
    • How to enable remote management(Dataplicity)
    • How to enable pihole management
    • How to build pikonek wifi vendo with coin acceptor
    • How to enable wireless sub vendo
  • Videos
  • Contact Us
Powered by GitBook
On this page
  • Assumptions
  • Steps
  1. Guides

How to enable remote management(Dataplicity)

PreviousHow to enable remote management(Ngrok)NextHow to enable pihole management

Last updated 10 months ago

This guide will show you how to enable remote management using dataplicity.

Assumptions

This assumes that you have a dataplicity account. To create go to

Steps

After creating an account. Open the pikonek admin dashboard http://pi.konek/fh

Go to Packages > Dataplicity

Under Dataplicity.

Provide your username and password for your dataplicity account

Hit the Save button

Click OK. This will install dataplicity and wait for it to finish

After successful installation. Go to your dataplicity dashboard

You will see now your device. Click the device and you will be connected

To access the administrator dashboard via dataplicity. You must enable the wormhole

To access the administrator dashboard, go to https://{wormhole-url}/fh

Click the chain button and under Wormhole click the button. This will give us a URL.

⛓️
dataplicity.com